Chaparral 100c Plus ¡¡

Discussions about controllers used to position your dish and track the satellite arc.
Post Reply
JDavid22
TVRO Member
TVRO Member
Articles: 0
Posts: 6
Joined: Wed Aug 14, 2019 1:29 am

Chaparral 100c Plus ¡¡

Post by JDavid22 » Wed Aug 14, 2019 1:39 pm

I just bought this equipment and I have many doubts. The main one catches my attention because of the risk I read, I must be careful about the damage to the Motor, even the antenna itself. The "Limits" values east and west from where I get them or is it the same equipment that is giving me these values according to the satellites I configure? Just as it comes to me it brings values east and west of 5000. I do not understand much of this I hope someone can help me, I am grateful in advance.

zack
TVRO Member
TVRO Member
Articles: 0
Posts: 19
Joined: Thu Sep 28, 2017 7:10 pm

Re: Chaparral 100c Plus ¡¡

Post by zack » Wed Aug 14, 2019 9:29 pm

Welcome, J!

If you set the mechanical limit switches in your motor arm properly, you need not fear damage!

I hope this link works!

https://www.satelliteguys.us/xen/thread ... st-4183822

JDavid22
TVRO Member
TVRO Member
Articles: 0
Posts: 6
Joined: Wed Aug 14, 2019 1:29 am

Re: Chaparral 100c Plus ¡¡

Post by JDavid22 » Thu Aug 15, 2019 1:34 am

Good evening, I am analyzing the information of the link, the doubts are being solved little by little, thanks for all the help, as I progress in this great project I will ask for more help there is surely a lot to learn!

Post Reply

Return to “Positioners”