We sent you the quotation TWO times. Please check your spam folder because it seems you are not receiving our communications.

You can also register on this forum and send me a private message.

If you do not already have one, I would also consider getting a weather boot for the actuator. I'm sure the same sponsor tek2000 carries those also. Good Luck! :grin: Yes, we do! All actuators, including boots, can be searched here http://www.tek2000.com/cgi-bin/web.cgi?command=product_index_search...

Got one 13.5' and one 15' mesh antennas left.

All other large antennas are sold out.

Now sold out!

I was wondering if I have to reshape the ends of the feed support struts. Yes, but the procedure is very simple. Use a pair of pliers and bend each end about 45 degrees , but in the opposite direction . The strut end with the 2 holes bolts to the scalar ring, while the strut end with a single hold ...

All, We have a few 8 foot mesh polar mount dishes available. They are the most recent model (2019) . You can purchase the antenna by itself or the complete motorized kit. We also have buried poles, king posts and pyramid base poles for these antennas. If anyone is interested, you can purchase here 8...

All,

The solid 12 footers are sold out!!

If you are a TV/Radio station, we still have some 10', 13.5' and 15' mesh antennas left, but they won't last long!!

eelstrebor wrote: ↑

Fri Nov 13, 2020 2:00 pm

What is this for? My finger is pointing at it.

It is for attaching the 8 steel rear panel braces!

Only the 12' and larger antennas have brace support. The purpose is to prevent deformation of the reflector under high wind and snow loads.