Hello,

We recently bought a titanium positioner which is capable of skewing an LNB using, I think a servo. We have a 10 foot dish with a stationary LNB. Does skewing the LNB help reception in any way? Is skewing tilting or rotating the LNB? Any...

Hello, recently I moved of location and my C band dish was disarmed, and the declination bolts in polar mount was moved. My dish is a primefocus 1.80 mts, After that I armed the dish and I can receive Ku band signal on sat 58 west with a ku band...

Anyone has a hint or Idea of some sort if I'm better off using a FTA 30 LNBF on a DIY bracket aside a H &V C-band LNBF pointing in-worth to the center?

This instead of my Chiner dual band dual polarity beige LNBF?

I'm told here that the...

Good Afternoon
I have 2 Chaparral single Feedhorn stored, with 2 antique(1998) LNB, one is samsonic, compact, and the other is a norsat, is large, I dont know the number or model. The question is possible to get the new signals mpg4, 8psk, etc. with...

I have lost about 50 percent of the stations viewable on 97, 99, 101,103 West. This happened overnight this week. When I did a re-scan, I got the same result - most of the stations did not show up on the scan. I checked my alignment east/west, and...

Hello good night, again here consulting the experts, I have acquired a Dual C Band equipment but I get misaligned question in what way I can correct, in a part of the climbing ring it brings a kind of piston but it is very small and it is difficult...

Hello all. Sorry for the long story but I like to be very detailed.

I have been around the scene for 3-4 years and usually, with help from forums, I figure out what my next step is when I have an issue. Well, this time, I am not sure what the next...

I have a c/ku lnb that came with a scaler ring does the scaler ring have to be changed with every lnb you add

Just wondering, I have a 10ft. mesh Cband dish and an extra C band and Ku band lnb lying around. Is it worth it to add a Ku lnb in my set up. Not sure if. I would get good ku signal.

Thanks for your input.

Chris

Hello, this is my first post here other than the introduction I made.

My question is I'm planning on installing a C-Band dish system and I'm wondering as to the length of the feed line from the dish to the receiver. How long is too long before it...

All,

One of Charlie's itty-bitty dish installers (now turned C-band installer) is putting out inaccurate information about our 12' Mesh Dish. He claims the focal length for our dish is 51 . In actual fact, the correct focal length is closer to 52 ,...

Hey all,

Has any one seen a reverse Band ( 17.3 to 17.7 Ghz. ) LNB ?
Of course the Direct TV RB unit is beginning to show up on ebay
but I'm looking for something more FTA.

I'm very curious about what might be going on in this new band.
DTV is...

All,

If your nerdy enough your happy without demodulating !

Guess what the signal is on the Spectrum Analyzer ?

Hint: Center frequency 2.336 / 2.342 Ghz. @ 115W

foxcreek

Hi all,

Here's my new toy: :cool2

Well though I would ask. Am planning on getting a KU band to add to my C band LNB. Came across this S band. Any comments on this LNB for North America?

Spec.
Input Frequency: 2.3 to 2.7Ghz, 2.2 to2.7Ghz, 2.5 to 2.9Ghz, 2.3 to 2.9Ghz
L.O....

Has anyone played around with mulitmode feeds?

For those that don't know, our regular scalar ring, LNBs, LNBFs are all designed to capture just one mode (dominant mode or TE11) of RF power, even though there are an infinite number of RF modes in...

I have a C/Ku band LMB, when I installed this I just put the Dielectric plate in and thought that is how it works. So as I'm reading here I get the impression that I will receive only circular signals, but to receive horizontal or vertical I need to...

FullSizeRender (4).jpg FullSizeRender (4).jpg FullSizeRender (3).jpg IMG_1233.JPG How do I rotate between V&H? Or would I be better off with something like one or the other of the above ? Thanks! Sorry I posted same pic twice ! I cant get rid of the...

Anyone know of a source for a commercial, prime-focus Ku-LNBFs?

Here is an example of multi-focus feed for C and Ku Band reception that I prototyped for myself.

It consists of 4 LNBs:

1. The center C-Band LNB for linearly polarized (V/H) reception. The majority of C-Band signals available in North America are...

blah blah

Just received my new CL-242 lnbf from Tek2000. I currently have a bsc422 dual lnbf on my 10' bud but I'd like to test feeds before I batten down the hatches for Winter. I will be using my azbox outside as its signal quality meter is the best of all...

Is there an LNB that will receive both Linear and Circular signals without a dielectric plate?