NewActuator Motor (Heavy Duty)
-
- TVRO Guru
- Articles: 0
- Posts: 35
- Joined: Wed Aug 14, 2019 1:29 am
- Has thanked: 13 times
- Been thanked: 3 times
NewActuator Motor (Heavy Duty)
Hello good night, a few weeks ago I bought an Actuator Motor Housing (Heavy Duty) in the tek2000 store as a substitute for my mechanical arm that is still in good condition and which I show you my doubt is that I bought a Heavy Duty engine (2.0 inch ) But today when I try to place it does not fit! Could you suggest what to do? Apparently the mechanical arms are different from the one I currently have.
Tags:
-
- TVRO Member
- Articles: 0
- Posts: 38
- Joined: Mon Aug 03, 2015 10:51 pm
- Location: Somewhere north of Toronto (in grid FN04)
- Contact:
Re: NewActuator Motor (Heavy Duty)
That sucks. Inside dimensions are different and looks like the drive pins are different too.
I’m surprised it wasn’t much more to just buy a whole new actuator . I’d bet the worm drives strip more than the motors burn out...but u said your screw arm is ok.
I have a stripped actuator worm drive . Other than having a new internal nylon worm drive made or turned on a laythe ( I’ve tried to reform it, shim it it...no go) ,I have to replace mine. It’s a heavy duty ...the drive motor is fine...I’d have to check it but maybe it will fit yours.
Probably easier to just return yours ( shipping cost will suck) ..
Is your old motor dead for sure? Did you test it completely ?
By pass the limit micro switches, check windings for resistance etc?
I’m surprised it wasn’t much more to just buy a whole new actuator . I’d bet the worm drives strip more than the motors burn out...but u said your screw arm is ok.
I have a stripped actuator worm drive . Other than having a new internal nylon worm drive made or turned on a laythe ( I’ve tried to reform it, shim it it...no go) ,I have to replace mine. It’s a heavy duty ...the drive motor is fine...I’d have to check it but maybe it will fit yours.
Probably easier to just return yours ( shipping cost will suck) ..
Is your old motor dead for sure? Did you test it completely ?
By pass the limit micro switches, check windings for resistance etc?
-
- TVRO Guru
- Articles: 0
- Posts: 35
- Joined: Wed Aug 14, 2019 1:29 am
- Has thanked: 13 times
- Been thanked: 3 times
Re: NewActuator Motor (Heavy Duty)
In fact, I have two engines, one totally unusable, it was very low in bad weather and water ... the other one by mistake I wanted to take it apart and ruin it ... a new engine like the one I need comes out in 89 dollars plus I send a new one 280 dollars plus shipping is just trying to save a little already with the expense maybe you choose to buy a new Ball Screw actuator of 24 "as my interest is the satellites from 40w to 133w at the most appropriate the polar mount to receive the actuator on the left side so it is like I plan to solve the problem. I can't do anything about the engine but try to sell it here in Mexico. Thank you for your comments....