Single Mode Ortho Feeds and more
Posted: Fri Aug 23, 2019 3:29 pm
All,
Some new products are available in our store. See below.
1. Single Mode Ortho Feed (Commercial)
This is a single output orthogonal C-Band feed horn used for the reception of either Vertical or Horizontal microwaves. It includes a mini LNB which bolts to the end of the waveguide.
It is designed to receive a single microwave polarization and conduct it to the mini LNB for down conversion. Available in extended band (3.4 - 4.2 GHz) and narrow band (3.7 - 4.2 GHz).
It is more efficient than a dual orthogonal feed due to better impedance matching and less cross-polarization interference. Since only one mode is bouncing around inside the waveguide, you will get the highest possible C/N ratio with this feed. If you want both polarizations, you need to add a rotator.
2. Adjustable Wall Mount
Introducing our Adjustable Exterior Wall Mount Stabilizer. This mount is designed so that its position can be adjusted beyond the eave of a building.
This mount comes in handy if you need to install your c band antenna above the roof eave of your house or garage. We recommend using a wall mount stabilizer for every 10 feet of pole length and the pole base should be buried in concrete or anchored to a cement pad.
Adjustable in length between 4 - 18 inches and supports pole diameters ranging from 3 - 7 inches.
3. Wire Mesh
Replacement wire mesh for our C Band consumer mesh antennas. Mesh thickness is 1.5mm and the hole size is less than 1.5mm.
Got a torn or damaged mesh reflector panel that you want to repair? No problem, just order the wire mesh quantity you need and make your dish brand new again!
Looking forward to seeing you back in our store soon!
Some new products are available in our store. See below.
1. Single Mode Ortho Feed (Commercial)
This is a single output orthogonal C-Band feed horn used for the reception of either Vertical or Horizontal microwaves. It includes a mini LNB which bolts to the end of the waveguide.
It is designed to receive a single microwave polarization and conduct it to the mini LNB for down conversion. Available in extended band (3.4 - 4.2 GHz) and narrow band (3.7 - 4.2 GHz).
It is more efficient than a dual orthogonal feed due to better impedance matching and less cross-polarization interference. Since only one mode is bouncing around inside the waveguide, you will get the highest possible C/N ratio with this feed. If you want both polarizations, you need to add a rotator.
2. Adjustable Wall Mount
Introducing our Adjustable Exterior Wall Mount Stabilizer. This mount is designed so that its position can be adjusted beyond the eave of a building.
This mount comes in handy if you need to install your c band antenna above the roof eave of your house or garage. We recommend using a wall mount stabilizer for every 10 feet of pole length and the pole base should be buried in concrete or anchored to a cement pad.
Adjustable in length between 4 - 18 inches and supports pole diameters ranging from 3 - 7 inches.
3. Wire Mesh
Replacement wire mesh for our C Band consumer mesh antennas. Mesh thickness is 1.5mm and the hole size is less than 1.5mm.
Got a torn or damaged mesh reflector panel that you want to repair? No problem, just order the wire mesh quantity you need and make your dish brand new again!
Looking forward to seeing you back in our store soon!